Hvlp Spray Gun Troubleshooting
Hvlp spray gun troubleshooting. Trigger gun just before the edge of the surface to be. TROUBLESHOOTING TROUBLESHOOTING Continued Problem Encountered Possible Cause Corrective Action Problem Encountered Possible Cause Corrective Action Heavy top or bottom pattern. HVLP Spray Gun Problem 1 My HVLP Spray Gun is not providing a good finish my paint appears chunky or uneven Orange Peel If you have problems with achieving a smooth finish when using HVLP it is one of few problems.
We list different conditions probable causes and fixes. Fluid Leaking from Cup. Trigger gun just before the edge of the surface to be.
Find the arrow-shaped handle and turn it so that it is pointing backwards. For full rebuild and cleaning of the gun use dedicated Paint Gun Cleaner by soaking the gun and parts in a clean mixing cup. If youre unsure check the paints technical data sheet.
Contractor Owner Support Education Center FinishPro HVLP Sprayers Troubleshooting. To separate the two halves of the HVLP spray gun follow the steps below. Gun too far from surface.
Swivel the trigger releases on both sides of the spray gun so they are pointing up. Make sure the paint you are using is designed for HVLP guns. HVLP Spray Pattern Problems If your HVLP spray gun is spraying inconsistent patterns ie.
Adjust to proper distance. If either is not the cause of the problem try to check if the spray gun is clogged. Dont tilt the gun in any direction.
Refer to the Troubleshooting Section. Assess room temperature since paint tends to clump when subjected to temperatures below 60 degrees Fahrenheit.
Contractor Owner Support Education Center FinishPro HVLP Sprayers Troubleshooting.
Each 3M Automatic HVLP Spray Gun is intended for use by professionals who are familiar with the possible applicable safety hazards. Aim the gun into a waste pail or scrap piece of cardboard and pull the trigger. HVLP Spray Gun Problems and Their Solutions HVLP Spray Gun Problems and Solutions. Material drying too fast. Use a slower solvent or add a retarding agent. Swivel the trigger releases on both sides of the spray gun so they are pointing up. If either is not the cause of the problem try to check if the spray gun is clogged. Start by spraying Injected Aerosol Cleaner through the gun to break any debris free. While looking at the rear of the.
Assess room temperature since paint tends to clump when subjected to temperatures below 60 degrees Fahrenheit. If either is not the cause of the problem try to check if the spray gun is clogged. Find the arrow-shaped handle and turn it so that it is pointing backwards. Push the lever toward the rear of the gun to unlock the two gun halves. Trigger gun just before the edge of the surface to be. Hold gun perpendicular 6 to 8 HVLP guns or 8-10 suction gravity or pressure conventional feed guns to surface being sprayed. Make sure the paint you are using is designed for HVLP guns.
Post a Comment for "Hvlp Spray Gun Troubleshooting"